Decal Application Instructions
Installation note: Application surface should be dry, smooth and be 50 to 90 degrees for best results. The vinyl decal can be applied dry or wet. Using the dry method does not allow for any mistakes and once the decal touches the surface, it can not be removed. However, if using the wet method by applying a light mist of application fluid, this allows for re-positioning and reduces the chance for bubbles and wrinkles.
Application fluid: Few drops of dish soap (dawn) in warm water
Step 1: Run a small plastic squeegee or a credit card over the surface of the decal to activate the decal application tape.
Step 2: Clean the dry, flat, smooth surface where the decal will be applied.
Step 3: Slowly separate and remove the application tape with the attached decal from the paper backing. If the decal stays on the paper backing, repeat step 1.
Step 4: Refer to the installation notes to determine which application method to use. Place the decal onto the surface and run over it with a squeegee or credit card to smooth out.
Step 5: Slowly remove the application paper at a steep angle, so that the decal remains on the surface. If the decal begins to peel up, run the squeegee or credit card over it again. Note: If using a wet method, allow the decal to dry for 30 minutes before proceeding with step 5.